Crawl Space Repair Before & After Photos

This crawlspace has tons of water in it due to a drainage problem. This left the home susceptible to condensation in the crawlspace which causes the floors to rot, a musty smell, and many more issues. We were able to pump all the water out and lay our CleanSpace Crawlspace Encapsulation system to prevent from these problems from occurring in the future.

These homeowners were unfortunately a bit late to tackling their crawl space moisture problems and had to have their floors replaced due to the damage. Immediately after, they reached out to us, searching for a way to prepare the underside of their home and prevent this from happening again. We sent out one of our system design specialists, Andrew, to take a thorough look and create a plan. Since then, one of our crews have already been out, and the solution they needed, an encapsulation, has been installed. You can see the major difference in the images! The crawl space has been sealed, it is protected with our CleanSpace Liner, and the mess has been taken care of!

When we originally entered this crawl space, we found bit of a mess, most noticeably, a lot of falling insulation. The moist and humid crawl space has soaked the insulation, weighing it down and dragging it downward. All of this wet insulation contributed greatly to the moisture problem and the moisture damage that led these homeowners to needing to replace their floors. That is a very unfortunate result, but we're showed up to make sure they never need to go that route again! Our encapsulation system fights moisture from all different angles. By sealing off the crawl space and turning it into a regulated, dry environment, the insulation will not even need to be replaced! Check out the major change in the provided pictures.

This crawlspace was set right above our 12" benchmark to install an encapsulation. Anything under 12" is too low for our guys and products to get under. 

This house originally had lattice work wrapped around the perimeter of the crawlspace, leaving it susceptible to outside air. Thankfully, the homeowner had this bricked in, in anticipation of the encapsulation. Once this was done, our guys came out and installed our encapsulation system utilizing the sump pump, dehumidifier, drainage matting, and 20 mil liner. Now this crawlspace will be able to dry out without the influence of humidity and ground water seepage.

This once wet and humid crawl space has been transformed by both our encapsulation and smartjack systems. The CleanSpace Liner you see throughout the whole underside of the home is helping tackle the moisture problem. It is much more durable than your average vapor barrier, and is tightly secured to the walls and floors of the space. Also seen in the photo is one of our smart jacks. These act as a permanent support system for the joists/floors that were already affected by the moisture. They can even be adjusted to fit the home's needs as it shift throughout the years. Unseen in the photo is our crawl space dehumidifier and sump pump system, which both also work towards keeping the space dry and healthy. Great job to our design specialists and crew members who planned and installed this job!